Before installing the firmware please contact our support. Updating the firmware of the CNC machine
The firmware is the internal control software of your CNC machine. New versions may introduce new functions and improve existing ones. You receive new firmware versions on the following ways:
Together with new versions of DentalCNC.
Obtain them regularly.
Damaging of the control unit when a firmware update is interrupted
If the firmware update is interrupted, for example by a power outage, by disconnecting the USB connection between the computer and the CNC machine, by closing DentalCNC etc., the control unit of the machine may take permanent damage.
Only update the firmware when a permanent electrical supply of the machine and the computer is guaranteed.
Only update the firmware if the computer runs stably and is free of malware.
Do not disconnect the CNC machine or the computer from the electrical source and do not switch off the machine or the computer during an update.
Do not close DentalCNC during an update.
In the following you find the current setup file in ZIP format for our software SilaMill.
SILADENT Dr. Böhme & Schöps GmbH
Im Klei 26
D - 38644 Goslar GERMANY
+49 (0) 53 21 / 37 79 0
+49 (0) 53 21 / 38 96 32
The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.